Software Guide
Setup guides, protocol tutorials, and tips for NOTABLE Windy software.
Build a Protocol in 3 Steps
Windy simplifies complex liquid handling protocols into a three-step wizard. No coding knowledge required · anyone can start automating experiments right away.
LABWARE · Deck Layout Setup
Place tip boxes, plates, tubes, and other labware onto the deck. Simply drag and drop each item into the desired slot.
WELL · Well Selection & Transfer Settings
Drag to select source and target wells. Set volume, aspiration/dispense speed, mix count, and other parameters through an intuitive UI.
OPTIONS & RUN · Review and Execute
Review the full protocol and verify with simulation before running. Completed protocols can be saved and reused at any time.
How to Use Key Features
Transfer
Transfer a specified volume of liquid from source wells to target wells. Supports simultaneous multi-channel transfer. Fine-tune options such as Tip Depth, Blowout Volume, and Touch Tip.
Mix
Mix samples by repeatedly aspirating and dispensing in a specified well. Set the number of cycles, volume, and speed independently. Note: renaming a Mix Step may cause a UI screen transition · close and reopen the screen to confirm changes.
Save & Reuse Protocol
Completed protocols are saved as local files. Load a saved protocol to modify parameters or run it immediately as-is. The Re Run feature may be unstable · we recommend closing the protocol and relaunching for a fresh run.
Stopping a Protocol Mid-Run
Press the [STOP] button during a run to display a confirmation popup. Select YES to stop immediately, or NO to pause and resume later. Never reach inside the instrument while it is powered on · always stop the protocol through the software first.
Select Wells by Dragging
Drag across a 96-well plate to select a range of wells. Individual click selection and pattern-based selection (by row or column) are also supported.
-
Drag to select a continuous range -
Ctrl+click to add individual wells -
Bulk selection by row or column -
Volume auto-distributed evenly across selected wells
Optimal Settings by Liquid Type
Aqueous Solutions (buffers, water)
- Aspiration speed: default setting works well
- Blowout: set to Tip Waste
- Pre-wetting: not required
Viscous Liquids (serum, glycerol, oil)
- Aspiration/dispense speed: reduce to 50-70% of default
- Blowout Volume: increase
- Pre-wetting: aspirate/dispense 1-2 times before run
Small Volumes (<5µL)
- Aspiration speed: set to minimum
- Tip Depth: position well below the liquid surface
- Pre-wetting recommended
Foamy Liquids (detergents, surfactants)
- Dispense speed: set to minimum
- Tip Depth: position close to the bottom of the well
- Touch Tip: enable recommended
Learn faster with videos
Four essential videos for new users to get started
Windy Basics
From first install to running your first protocol
Windy Advanced
Variables, loops, and complex protocol design
NOTABLE Hardware Overview
Hardware components and key features at a glance
Pipette Module Replacement
Maintenance · switching between 1ch and 8ch modules
Still need help?
Our dedicated FSE (Field Service Engineer) team is here to support you directly.
Reach out by email for hands-on assistance.
